List, Last year Mark Dierauf detailed his method of retro-fitting the Steinway pitman. I've had great success using his method in the post reprinted below from the archives: "I'm using 3/8" dowel with a 5/8" punching. Also, rather than drilling a shallow hole in the tray and trap lever, I use a roughly 1" square of 1/4" cowhide, with a 5/8" hole drilled through it, on both the tray and lever. I can position these and the new pitman, lined up through the hole through the keybed, until I get the straightest run. Then I mark their positions, remove the pitman and glue the leather blocks in place. An appropriate wedge under the tray acts as a clamp, and I use a spring clamp on the trap lever. Gluing the rough side of the lever with titebond, it dries adequately in a minute or so, and if I should screw something up I figure it will be a lot easier to remove the leather blocks than to un-drill holes in the parts. If you're dealing with an older Steinway with the 5/8" original pitman, it isn't even necessary to drill out the hole through the keybed." - Mark Dierauf THANKS MARK!! David Ilvedson, RPT Pacifica, CA 94044 -------------- next part -------------- An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/20080610/fbaa25fb/attachment.html
This PTG archive page provided courtesy of Moy Piano Service, LLC