Subject: Re: Yamaha pedal pivot Thanks, Tom. I've seen Eric Shandall demonstrate this trick on the shift-pin guide plates in S&S cheek blocks to great effect. In this case however the wear is pretty extreme (~2mm), so I'll be trying Ron's suggestion of J B Weld (I was secretly hoping that somebody would suggest it, Ron). That sounds a lot cheaper than a new set of pedals ;-) - Mark Dierauf Mark, I agree. JB weld would be my choice with that much wear. It's available in most hardware stores also. Tom d. No virus found in this outgoing message. Checked by AVG. Version: 7.5.524 / Virus Database: 269.23.6/1403 - Release Date: 4/29/2008 7:26 AM
This PTG archive page provided courtesy of Moy Piano Service, LLC