>Is there a ratio that can be looked upon as a standard with >the following scenario: >If you increase the key height by ... , you will increase >dip by ... . Something tells me it's not a 1:1 ratio. Where'd you get that something?... If you raise the key height 1mm, the dip will increase the same amount; 1:1. The only ratio aspect which is different and non-applicable is that the key height increases a smaller percentage than the dip: 62 mm key height increased to 63 mm is a .016% increase 10 mm dip increased to 11 mm is a 10% increase. But has no bearing on anything. -- Regards, Jon Page -------------- next part -------------- An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/20080511/8e852247/attachment.html
This PTG archive page provided courtesy of Moy Piano Service, LLC