Hello Everyone, I have a problem with a piano at a school. It is aYamaha T118 built in China. The screws in the pedal brackets have stripped out of the bottom board. The bottom board is 3/8" ply ( beaver barf ) and I am asked to repair it with plug with dowel and redrill. ?? The reason is if other technicians have to work on it in the future it will be to difficult. Personally I don't think it will hold, this ply is too thin and not very good quality. I want to drill the holes in the board and install with nuts and bolts. The pedals will then be bullet proof. Any suggestions? Regards, Jack houweling -------------- next part -------------- An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/20080528/18a846f3/attachment.html
This PTG archive page provided courtesy of Moy Piano Service, LLC