[pianotech] c clamp

[Joe Goss]

Dremel tool with cut off wheel then drill through slot for the divot. Haven't made or used one. Always use  a tipper and charge accordingly.
Joe Goss BSMusEd MMusEd RPT
imatunr at srvinet.com
www.mothergoosetools.com
  ----- Original Message ----- 
  From: AAA Piano Works, LLC 
  To: pianotech at ptg.org 
  Sent: Monday, December 28, 2009 3:43 PM
  Subject: Re: [pianotech] c clamp


  OK, sounds good.

   

  How would you make the slot?

   

  From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On Behalf Of Joe Goss
  Sent: Monday, December 28, 2009 5:16 PM
  To: pianotech at ptg.org
  Subject: Re: [pianotech] c clamp

   

  Hi Brian, Think of it as a center pin removal tool.

  Just slot out the foot of a clamp?

  Joe Goss BSMusEd MMusEd RPT
  imatunr at srvinet.com
  www.mothergoosetools.com

    ----- Original Message ----- 

    From: Brian Doepke 

    To: pianotech at ptg.org 

    Sent: Monday, December 28, 2009 2:56 PM

    Subject: [pianotech] c clamp

     

    While reading through an old Journal ( June 2003, page 10) a tool was described that would make it easier to remove the pedals without taking off the bottom board.

     

    However, during the description of the tool used to remove the pedal pivot pin, several critical items were left out.

    For example, how big do you make the hole.what size drill bit is required?  3/8" ??

     

    How can anyone get a good ,FLAT< drilling surface when trying to drill through the "top part of the clamp body"?

     

    Mr. Nereson, RPT of Denver uses this tool, and it sounds like a great idea.  But, could I get some more details, please?

     

    Brian P. Doepke, M.Mus.Ed.,RPT

    A.A.A. Piano Works, LLC

    Piano Tuning + Service

    www.aaapianoworks.com

     
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://ptg.org/pipermail/pianotech.php/attachments/20091228/919bf804/attachment.htm>