If your father made it, it probably is 3/8 inch... David Ilvedson, RPT Pacifica, CA 94044 Original message From: To: Received: 2/27/2009 1:02:13 PM Subject: Re: [pianotech] Erwins key dip gauge Yep, the ends are different sizes. One is brass the other aluminum for quick visual reference while using. I haven't used one in a while and can't, for the life of me, remember each end's diameter. Having the double end also makes for a nice handle and better balance. Debbie L. ----- Original Message ----- From: erwinspiano at aol.com To: pianotech at ptg.org Sent: Friday, February 27, 2009 11:41 AM Subject: Re: [pianotech] Erwins key dip gauge HI Debbie Very similar & douple ended. Are these different diameters? Dale -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://ptg.org/pipermail/pianotech_ptg.org/attachments/20090227/de53ac85/attachment.html>
This PTG archive page provided courtesy of Moy Piano Service, LLC