?? Paul ? Thanks ? Dale Dale, http://www.metricmetal.com/products/round.htm Paul (I've never ordered from them) Bruesch On Sat, Feb 28, 2009 at 5:42 PM, <erwinspiano at aol.com> wrote: Jim ? Metric brass is impossible to find I'm told. If I can find a source I'd make new gauges with? another piece of 10 mm on the other end.... or not. ?By the way what is the standard equivalent of 10 mm exactly. Bet it's slightly less than .390 ? ?Dale -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://ptg.org/pipermail/pianotech_ptg.org/attachments/20090301/2275d2f2/attachment-0001.html>
This PTG archive page provided courtesy of Moy Piano Service, LLC