Hi Don Could you explain wet sizing? Dean Dean May cell 812.239.3359 PianoRebuilders.com 812.235.5272 Terre Haute IN 47802 -----Original Message----- From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On Behalf Of Don Mannino Sent: Tuesday, January 06, 2009 12:27 AM To: drjazzca at yahoo.ca; pianotech at ptg.org Subject: [pianotech] Friction Levels in Action Centers <snip> There was a time in the 80s when I was taking new actions from a well known piano company, wet-sizing the bushings in the hammers centers, then taking out the factory #19 pins and replacing them with #20 or 20-1/2. The difference in tone and performance was amazing, because the original bushings were too thick and spongy. Hope this helps. Don Mannino
This PTG archive page provided courtesy of Moy Piano Service, LLC