I'm doing it on this M&H A I'm re-stringing...only since the pins are waaay too tight. I tested a couple and they're good now...(with the turning out and in method..) While on practice room grands, I always just turn out and in for time reasons. If they turn out a little loose, I apply some CA. I do agree to making the coils first if the pins are regular in tightness....How about Baldwins, y'all? The last few years I tuned new ones in a store, they were massively tight and jumpy? Paul Jim Busby <jim_busby at BYU.EDU> Sent by: pianotech-bounces at ptg.org 06/04/2009 12:59 PM Please respond to pianotech at ptg.org To "pianotech at ptg.org" <pianotech at ptg.org> cc Subject Re: [pianotech] string replacement All, In a chapter technical we measured torque after coming out 4 turns then back in, and it was an eye opener. The less turning, the better. Especially if the torque is low to begin with. Doing it twice and you almost needed a pin size bigger on some blocks! Unless it's a Nossaman block where the Delignit cap seems to take more abuse. Older blocks seemed more affected by this in/out thing. Therefore, I'd NOT back the pin out 3 or 4 turns if you can help it. With some blocks even this seemingly small thing will make the pin too loose. Instead, back it out only enough to get the string off (one turn or less), make the coil with your coil maker or dummy pin. Unless, of course, the pin was too low (close) to the plate and you're trying to remedy that. Jim Busby p.s. I don't remember the torque readings, but it was enough to make me stop turning the pins out... -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://ptg.org/pipermail/pianotech.php/attachments/20090604/56a83e10/attachment.htm>
This PTG archive page provided courtesy of Moy Piano Service, LLC