Conrad: Take a look under a microscope at the internal surface of the agraffe after using this tool. If we are worried about transient noise....hmmm. Paul In a message dated 3/5/2009 1:42:43 P.M. Central Standard Time, hoffsoco at luther.edu writes: On 3/5/09, Al Guecia/AlliedPianoCraft <AlliedPianoCraft at hotmail.com> wrote: > But we do use brass agraffes with no problem. > > Al > Oh? Then why did I get a special double end mill to dress oval agraffe holes? Another useless tool? -- Conrad Hoffsommer, RPT Luther College Decorah, IA **************A Good Credit Score is 700 or Above. See yours in just 2 easy steps! (http://pr.atwola.com/promoclk/100126575x1219957551x1201325337/aol?redir=http:%2F%2Fwww.freecreditreport.com%2Fpm%2Fdefault.aspx%3Fsc%3D668072%26hmpgID %3D62%26bcd%3DfebemailfooterNO62) -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://ptg.org/pipermail/pianotech_ptg.org/attachments/20090305/c3f58718/attachment.html>
This PTG archive page provided courtesy of Moy Piano Service, LLC