[pianotech] V-Bar Dilemma

[Greg Newell]

Wow, what a mess! Would stainless work, (assuming you could get someone to
make it)?

Greg Newell
Greg's Piano Forté
www.gregspianoforte.com
216-226-3791 (office)
216-470-8634 (mobile)

-----Original Message-----
From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On Behalf
Of Jon Page
Sent: Wednesday, March 11, 2009 4:11 PM
To: pianotech at ptg.org
Subject: Re: [pianotech] V-Bar Dilemma

Here's two pix of the items in question. A channel was milled into the bar
to hold these inserts. To make matters worse, the down bearing leaves
something to be desired too.

I thought they had their act together by then...

Regards,

Jon Page