[pianotech] Renner hammer boring jig

[Oorebeek]

For years I have used the hammer boring jig made by Renner USA.
What a fantastic thing!
Very very easy to operate.
All you need is a bigger drill standard, some clamps and very good  
drills.
According to me the easiest one in the world.

OOR




On May 3, 2009, at 9:08 AM, David Ilvedson wrote:

> Marco,
>
> There must be some mistake?   That looks just like my cappuccino  
> maker...  '-]
>
> David Ilvedson, RPT
> Pacifica, CA  94044
>
> ----- Original message ----------------------------------------
> From: "piano workshop" <info at pianoworkshopny.com>
> To: pianotech at ptg.org
> Received: 5/2/2009 10:01:35 AM
> Subject: Re: [pianotech] Renner hammer boring jig
>
>
>> This is the right boring machine ever...for my opinion.
>> It's expensive but do is job accurately.
>> These machine its Made in Italy but sold by Jahn - Germany.
>> I work with it more than 10 years without any problem.
>> Easy to set easy to use.
>
>> Marco De Lellis
>> Piano Workshop Inc.
>> PTG - Registered Piano Technician
>> 21-05 31st. Avenue
>> Astoria New York, 11106
>> USA
>> tel. 001 212 575 4949
>> tel. 001 718 956 3110
>> www.pianoworkshopny.com
>> info at pianoworkshopny.com
>>
>
>> -----Original Message-----
>> From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org]  
>> On Behalf
>> Of Mark Dierauf
>> Sent: Saturday, May 02, 2009 9:32 AM
>> To: Pianotech
>> Subject: [pianotech] Renner hammer boring jig
>
>> Does anybody know if this jig will bore vertical hammers as well as
>> grands? I'm particularly wondering if it is capable of boring the
>> extreme rake angle found on the old S&S uprights. Thanks,
>
>> - Mark
>
>
>
>
>


friendly greetings
from
André Oorebeek

Antoni van Leeuwenhoekweg 15
1401 VW, Bussum
the Netherlands

tel :    +31 35 6975840
gsm : +31 652 388008

www.concertpianoservice.nl

"per aspera ad astra"
(through hardship to the stars)






-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://ptg.org/pipermail/pianotech_ptg.org/attachments/20090503/3de9f1fe/attachment.html>