Yes. All I was pointing out is that if every string on a piano is one semitone flat before doing anything, when you start raising pitch from A0, the increased tension added to each string as you go along will cause the treble-more strings to fall in pitch. So that once you get to the upper tenor for example, the strings will be approximately 125 to 139 cents flat - and the treble a bit more than that - but that's okay, because the ETD will calculate require overpull based on the string pitch after it has been influenced by earlier strings. Terry Farrell On Jul 3, 2010, at 12:33 AM, Ron Nossaman wrote: > Terry Farrell wrote: >> Correct on the overpull. But I find that medium and larger sized >> pianos require somewhere in the range of 38% overpull. This guy >> said the piano was a semitone flat. When you pull up the pitch >> starting from A0, that will cause the strings toward the treble to >> drop in pitch. As the pitch raise proceeds through the tenor to the >> treble, I would expect that the next note in the treble would be >> 130, 140 or so cents flat, and requiring something approximating a >> 50 or 60 cent overpull. Every piano is different, of course. > > I'm told over and over that ETDs calculate this stuff automatically, > so the poor backward aural tuner doesn't have to guess on pitch > raises. Accurate one pass pitch raises is one of the primary > leverage points for ETD use, isn't it? > > Ron N
This PTG archive page provided courtesy of Moy Piano Service, LLC