Mike Spalding wrote: > For aligning plate to case, here's what I do: Make two "headless > screws" by sawing the heads off of two #18 x 3" wood screws, and slot > the ends with hacksaw or dremel. Before removing the plate, drill two > 1/4" holes down through the plate and into the rim, near each end of the > long bridge. (Caution - locate the holes slightly off from the midpoint > between plate bolts to avoid drilling into the button screws on M&H > grands) Re-drill the plate only to 5/16 diameter, and screw the > headless screws into the rim until the the top of the screw is flush > with the plate. I use a couple of tuning pins, similarly positioned, driven upside down into the rim. Ron N
This PTG archive page provided courtesy of Moy Piano Service, LLC