Re: [pianotech] Bouncing BostonsJon, What's your opinion on the ideal thickness at the balance hole ? Thanks, Tom Driscoll ----- Original Message ----- From: Jon Page To: pianotech at ptg.org Sent: Saturday, July 31, 2010 6:37 AM Subject: Re: [pianotech] Bouncing Bostons >tight balance rail holes (and possibly too thick as well) To check the balance hole height, insert a wire alongside the pin until it stops at the 'top' of the b/h. Hold your thumb nail on the wire at the button surface. Remove the wire and place the wire aside an end key to gage the b/h height. You could also measure the height of the key at the button and subtract the length of your wire gage. -- Regards, Jon Page -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://ptg.org/pipermail/pianotech.php/attachments/20100731/297c3dbf/attachment.htm>
This PTG archive page provided courtesy of Moy Piano Service, LLC