The question was whether the Tormek system had a procedure for flattening the back of the chisel since after the Tormek investment it would make sense to try and avoid having to invest in quality stones as well. David Love www.davidlovepianos.com -----Original Message----- From: PAULREVENKOJONES at aol.com Sender: pianotech-bounces at ptg.org Date: Sun, 10 Oct 2010 22:04:22 To: <pianotech at ptg.org> Reply-To: pianotech at ptg.org Subject: Re: [pianotech] Of Chisels On a stone. P In a message dated 10/10/2010 10:01:22 A.M. Central Daylight Time, davidlovepianos at comcast.net writes: I’m curious about those who use the Tormek system, how do you go about flattening the back of the chisel? David Love www.davidlovepianos.com From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On Behalf Of Thomas Cole Sent: Saturday, October 09, 2010 10:44 PM To: pianotech at ptg.org Subject: Re: [pianotech] Of Chisels Another thing I like doing is to square up the blade and at the same time remove any nicks in the edge (see photo). The Tormek system is great for recreating the bevel, but be careful you don't grind at a very low angle on Japanese chisels due to the brittleness of the high-carbon steel. Tom Cole William Truitt wrote: And, as you know Jim, you have to flatten the back on the chisel before you can begin to sharpen it. Which is why the backs of these chisel has one or more reliefs, which allows you to bring it to a flattened state much more quickly. -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://ptg.org/pipermail/pianotech.php/attachments/20101011/bc514e58/attachment.htm>
This PTG archive page provided courtesy of Moy Piano Service, LLC