On 9/19/2010 12:25 PM, John Ross wrote: > Hi Joe, > I have forced the screw to rethread, but thought if the proper die was available, I would buy it. > Thanks. > John Ross Hi John, It's a #4 screw, but a non-standard thread pitch. I don't have a thread gauge that goes finer than 40tpi, and these screws seem to be a finer thread than that. They're somewhere around 42tpi, I think. If they exist anywhere in the world new, I sure don't know where it would be unless someone makes a M2.5 x .6 metric screw. Ron N
This PTG archive page provided courtesy of Moy Piano Service, LLC