Will check it out. As for the old parts, it may take some time and I can't gurantee it. There's another pair of eyes looking over me. :) Regards Lim Sent from my BlackBerry Wireless Handheld Powered by Gee! from StarHub -----Original Message----- From: Ron Nossaman <rnossaman at cox.net> Sender: pianotech-bounces at ptg.org Date: Sat, 25 Sep 2010 12:38:24 To: <pianotech at ptg.org> Reply-To: pianotech at ptg.org Subject: Re: [pianotech] Steinway brass plate On 9/26/2010 3:21 AM, limhseng at gmail.com wrote: > Thanks Ron Is it alright to replace it with understring felt during > restringing? I suppose you could. The one I did a few years back, I just cleaned up the brass and put that back in. >Can I replace standard parts for the tied parts? I am > not sure whether they supply those tied parts anymore. Yes, standard parts (whatever those are <G>). Send me some of the old action parts? I didn't get to do the action of the one I restrung, and would like to get a few samples before they all disappear. Ron N
This PTG archive page provided courtesy of Moy Piano Service, LLC