Frank Nice paragraph on Cold pressed hammers on the site. Well done! It would be nice to see the tonal pendulam swing faster but this another tick tock in the right direction Dale S. Erwin www.Erwinspiano.com Custom piano restoration Ronsen piano hammers-sales R & D and tech support Sitka soundboard panels 209-577-8397 209-985-0990 -----Original Message----- From: George F Emerson <pianoguru at cox.net> To: pianotech at ptg.org Sent: Wed, Sep 29, 2010 9:38 am Subject: Re: [pianotech] Cold Pressed hammers was: Voicing the new Mason &Hamlins Dale Erwin wrote: >Good to hear,...now gaining the expertise on your own to operate and these presses and make consistent hammers is a tough trick since there are no living pressman in China. How are they doing it? Peter Veletzky, 4th generation Austrian master piano builder. http://hailun-pianos.com/engineers.php -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://ptg.org/pipermail/pianotech.php/attachments/20100929/74229bfc/attachment.htm>
This PTG archive page provided courtesy of Moy Piano Service, LLC