I think you would do well to not make an attempt ascribe motives to my posts. You're in no position. My point still stands. You don't need to move the string segment via the pin any farther than to achieve the target position where it will ultimately come to rest and/or require any settling back down. If you want to parse that in a way that suits you have at it. But be careful, you might grow warts on your palms. David Love www.davidlovepianos.com -----Original Message----- From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On Behalf Of Ron Nossaman Sent: Wednesday, February 02, 2011 10:42 AM To: pianotech at ptg.org Subject: Re: [pianotech] Hammer Technique: was Q & A Roundtable On 2/2/2011 12:28 PM, David Love wrote: > OK, this has gotten some convoluted and the point confused in all this back > and forth. It's only gotten convoluted because you have tried so hard to make it so, by avoiding my point. >You are right, the segment rises above the equilibrium tension > level until friction is overcome and the speaking length follows at which > time the first segment tension then drops. Yes, I know. And it's not me that's right. The physics demands it. I just stuck with it. >The point that I've been trying > to make is whether or not you need to *move* that segment beyond the point > at which it will ultimate come to rest at equilibrium, which you don't. More nonsense. If you've raised the tension above equilibrium, you've moved it. >It > would have been more correct for me to say that the physical movement > (rather than tension) of the segment beyond the point that will pull the > speaking length to its target pitch and leave the first segment at its final > equilibrium tension when the segments ultimately settle is unnecessary, and > that's what I tried to convey and demonstrate. That's better, and an early point that I addressed already that I still find it necessary to bump it up and down to verify where it is before moving on. And no, that has nothing to do with ETD use one way or the other. That's a wrap. I'm finished. Ron N
This PTG archive page provided courtesy of Moy Piano Service, LLC