Though you can measure the change in crown after letting down the tension by running a straight edge across the rim and measuring down to the bridge. David Love www.davidlovepianos.com -----Original Message----- From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On Behalf Of Ron Nossaman Sent: Tuesday, July 12, 2011 1:02 PM To: pianotech at ptg.org Subject: Re: [pianotech] Measuring Crown Radius On 7/12/2011 1:17 PM, Joe Goss wrote: > Q Is there a way to measure crown from the bridge side of the board? > Just Checked the crown on a SnS and had a wonderful time laying on the > spider supporting the piano. NOT Not reliably, since panels are often tapered, or thinned at the edges. Ron N
This PTG archive page provided courtesy of Moy Piano Service, LLC