Assuming it's actually hide glue... Heat AND moisture? You could drill a small hole into the shank at an angle from the butt, moisten, warm the bottom of shank (just above the butt) with a lighter or alcohol lamp. Paul Bruesch Stillwater, MN On Sat, Oct 1, 2011 at 3:01 PM, Ed Carwithen <edwcarw at yahoo.com> wrote: > I need to replace the hammers on an upright piano. Schaff wants the > sample hammers with the shaft attached. No matter what kind of solvent I > have tried the shaft stays fimly in the butt, and comes out of the hammer. > Yes, I am using the right hammer/butt extractor. Yes, I have removed the > glue collar around the shaft on the butt end. I have tried the wall paper > paste solvent, glue remover and acetone. No cigar! What will actually > dissolve the old glue? Any Ideas????? > > Ed Carwithen > John Day, OR > -------------- next part -------------- An HTML attachment was scrubbed... URL: <https://www.moypiano.com/ptg/pianotech.php/attachments/20111001/f799895b/attachment-0004.htm>
This PTG archive page provided courtesy of Moy Piano Service, LLC