Doug Gregg had a tip in the TT&T section of the Journal recently featuring these clamps as well. -John Parham > -------- Original Message -------- > Subject: Re: [pianotech] re-gluing loose hammer felt > From: Tom Gorley <tomgorley88 at sonic.net> > Date: Sat, February 04, 2012 2:47 pm > To: pianotech at ptg.org > > > About 6 months ago a tuner put us on to clamps that work perfectly for this job. I wish I could remember who, so I can give him credit. > Here is the website of the Garrett Wade Company and the correct page. > > http://www.garrettwade.com/ratchet-lock-spring-clamps/p/05R04.01/ > > > > > On Feb 4, 2012, at 10:57 AM, John Ross wrote: > > > I also use super glue. > > But the secret is to use two coats on the felt. > > When I first used it the felt soaked up the glue, and the joint was starved, and was hit and miss. > > Since i started to put it on the felt first, then reapply to the felt and wood later once the first coat on the felt had set. I have had no problem with failure. > > I use a vise to hold the hammer felt in place, so it has some tension. I also use curved wooden parts flat on one side to be square with the vise jaw. Just cut out of scrap hardwood. > > John Ross > > Windsor, Nova Scotia. > > On 04-02-2012, at 2:18 PM, tnrwim at aol.com wrote: > > > >> Chuck > >> > >> I've used super glue, clamping the felt with vice grips. It sets up in about a minute. > >> > >> Wim > >> > >> > >> > >> > >> -----Original Message----- > >> From: CHARLES BECKER <cbeckercpt at verizon.net> > >> To: PTG <pianotech at ptg.org> > >> Sent: Sat, Feb 4, 2012 4:59 am > >> Subject: [pianotech] re-gluing loose hammer felt > >> > >> Hello list, > >> > >> What is the best glue to use when regluing loose hammer felt to the moulding? > >> > >> Thanks in advance. > >> > >> Chuck Becker > >
This PTG archive page provided courtesy of Moy Piano Service, LLC