It is the key strip. Rick Ucci Uccipiano.com 609-677-0444 On Jan 28, 2013, at 3:05 PM, Paul Milkie <pgmilkie at yahoo.com> wrote: > I ment to say take key strip off. > > P Milkie > > From: Paul Milkie <pgmilkie at yahoo.com> > To: "pianotech at ptg.org" <pianotech at ptg.org> > Sent: Monday, January 28, 2013 12:56 PM > Subject: Re: [pianotech] Key rail > > Take key rail off, check to see if there is a screw in each cheek block,screwed in at downward angle into the keybed under the first and last key. > > Paul Milkie > > From: "richarducci at comcast.net" <richarducci at comcast.net> > To: "pianotech at ptg.org" <pianotech at ptg.org> > Sent: Monday, January 28, 2013 12:41 PM > Subject: Re: [pianotech] Key rail > > It does have slots. It doesn't slide far enough to take out. > > Rick Ucci > Uccipiano.com > 609-677-0444 > > On Jan 28, 2013, at 1:44 PM, John Formsma <formsma at gmail.com> wrote: > >> It's held together by either screws or friction. If you have already removed screws, the finish might be holding it in place. Tap...gently. If you can't locate screws, then gently pull in the middle or ends to see where the screws are. There should be some "give" at various places. >> >> It might be one of those pianos that have slots that the rail slides on. Some Story & Clark consoles have top lids like these. >> >> Don't panic...examine. Figure it out. It's just a piano. ;-) >> >> >> -- >> John Formsma, RPT >> Blue Mountain, MS >> >> >> >> On Mon, Jan 28, 2013 at 12:00 PM, <richarducci at comcast.net> wrote: >> Wurlitzer spinet ca:50's. >> I give up! How is this damn thing removed! >> >> >> >> >> >> Rick Ucci >> Uccipiano.com >> 609-677-0444 >> >> > > > > -------------- next part -------------- An HTML attachment was scrubbed... URL: <https://www.moypiano.com/ptg/pianotech.php/attachments/20130128/974d443c/attachment.htm>
This PTG archive page provided courtesy of Moy Piano Service, LLC