CA update procedure

[llafargue]

I get my CA from K&R Internationl, glue called E-ZBOND 1-866-239-2663.
They have a web site.  $100 minimum.  VERY CHEAP.  They have little
needle nose applicators to hook to the end of the bottle, works great
for me, several sizes of empty bottles to poor your 8,12,16 oz in.  I do
enough pinblocks and keep it in my shop fridge to justify the $ minimum
and it really saves a bunch in the long run.    

Lance Lafargue, RPT
LAFARGUE PIANOS
New Orleans Chapter, PTG
985.72P.IANO
llafargue@charter.net
 

-----Original Message-----
From: caut-bounces@ptg.org [mailto:caut-bounces@ptg.org] On Behalf Of
Joe And Penny Goss
Sent: Monday, January 26, 2004 10:15 AM
To: Calin; Pianotech; College and University Technicians
Subject: Re: CA update procedure

Hi Calin, and list, This is a update on ideas in  my use of CA glue in
treating loose tuning pins.
Great,
If you use the CA on a grand be sure to take the action out and cover
the
bed with news print ( paper ).
Also the glue will run a lot so the use of a very fine needle ( I use my
insulin micro fine needles ) will put the glue exactly where you want it
to
be. Use a paper towel near where you are working as each time you move
the
needle there may be some drips that go where you do not want them.
Also a two pass approach is best just like in tuning. And in sections of
perhaps 24 pins.
You may want to mark the top of the pins with chalk for each section
until
you get the idea of where you are going to go next. Treat a section at a
time with the first and go back over with a second pass.
Look for the welling up of the glue to let you know to stop but also as
a
warning that the glue is going down a crack. In this case stop and go on
to
the next pin letting the glue set up a little before adding more.`
You should be able to start tuning the instrument when the last pin is
treated as the moisture in the wood and friction of pressure will cause
the
glue to set up a little. Full cure in a day or so without any activator.
If you do an upright you may want the instrument to be on its back, but
I
have treated a few pins with the needle with the instrument standing. It
is
a pain in my back to do it this way but a few pins are not too bad.
Joe Goss
imatunr@srvinet.com
www.mothergoosetools.com

_______________________________________________
caut list info: https://www.moypiano.com/resources/#archives