---------------------- multipart/alternative attachment In a message dated 7/15/2005 6:55:35 PM Central Standard Time, stan@pianoexperts.mb.ca writes: Rather than poke a hole in the hammer, consider making a simple tool to carve a little slot in the shank for glue escapement. Easy to make, fast to do and keeps your nice hammer mouldings clean. Enjoy the weekend, all! Stan Kroeker, RPT Chris Solliday wrote: > Tight Bond Molding Glue available at some home centers or Pianotek. It > doesn't drip. Don't forget to drill or poke an escape hole through > the top of the hammer molding. Chris Solliday The slots in the side are a good way for the glue to escape. But the PTG technical exam makes you poke a hole in the hammer. Wim ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/caut.php/attachments/74/94/d3/8f/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC