This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment Hi, Any chance they forgot to chance drill sizes at the factory? If all are the same oversize this seems like a posibility. Joe Goss RPT Mother Goose Tools imatunr@srvinet.com www.mothergoosetools.com ----- Original Message -----=20 From: Jim Busby=20 To: College and University Technicians=20 Sent: Friday, March 25, 2005 10:44 AM Subject: RE: [CAUT] Pulley keys. List, (especially Don M.) =20 We just bought 9 new UST7s and all the keys are pulley! Not a huge = amount, but not acceptable. I wanted to size them but the pins are = smaller than what I have on hand. (.125 ??) However, just to let you = know how big the holes were some of the Yamaha pins would fit (.137) =20 My question is, has anyone else noticed this, and am I being too = nitpicky. (since this is only a vertical for heaven's sakes.) Does this = amount of "pully-ness" really make that much of a difference in an = upright used mainly for non majors? =20 Thanks, =20 Jim Busby RPT BYU =20 =20 ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/caut.php/attachments/55/4f/43/8d/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC