[CAUT] snap ring pliers

[Jim Busby]

Tim,

My last post was unclear... I see the block on the bottom, but is the
top jaw of the pliers slotted?

Jim

-----Original Message-----
From: caut-bounces at ptg.org [mailto:caut-bounces at ptg.org] On Behalf Of
Tim Coates
Sent: Tuesday, December 19, 2006 8:37 PM
To: College and University Technicians
Subject: [CAUT] snap ring pliers

Here are some pictures of the snap ring pliers.  An auto tool supply 
house should have them.  I used an action model to show them in use.  I 
made a slotted block in order for them to spread properly.   The action 
model actually has the shank/backcheck relationship I prefer   to use, 
even though it doesn't come across in this picture.

Tim Coates