---------------------- multipart/alternative attachment At 04:49 PM 2/18/2006 -0800, you wrote: >Hey Susan...how about a picture? > >David Ilvedson, RPT >Pacifica, California > I'll try to make one soon. > >---------- >Original message >From: "Susan Kline" >To: "College and University Technicians" >Received: 2/18/2006 3:31:32 PM >Subject: Re: [CAUT] Vertical hammer return spring slings, replacement of > >At 04:39 PM 2/18/2006 -0400, you wrote: >>If you have quite a few similar Yamahas, in your clientele. >>You could buy one set, and replace the flanges. >>Then in your spare time, re-cord the ones you removed. You then have an >>operational set, ready to replace for the next time. >>John M. Ross > >Ted Sambell gave me a nice little jig which holds the flange at an >adjustable distance from a little pin, with another bigger post to hold a >spool of cord. Run the cord around the pin, press it into both slots, add >a drop of CA each, then clip the end coming from the spool. Once you set >it up, the cords will all be the same length, without fiddling with all >the short bitsy pieces. But you do have to get the flanges out and back >in. Yes, it's easy to get the butts off the flanges when they have the >plates, but you still have to space, etc. > >Susan Kline ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/caut.php/attachments/b2/22/c2/85/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC