[CAUT] Work Sharp

[Paul T Williams]

What RPM does it run at?

PW




Tim Geinert <geinert at drtel.net> 
Sent by: caut-bounces at ptg.org
08/05/2008 09:25 AM
Please respond to
College and University Technicians <caut at ptg.org>


To
College and University Technicians <caut at ptg.org>
cc

Subject
Re: [CAUT] Work Sharp






Paul, List

You might also wish to look at the Surgi-Sharp system sold by Wapin 
Company.  
http://www.wapin.com/SurgiSharp_1.htm
It is for a 1x30 or 1x42 benchtop sander that is common and usefull,  is 
extremely versitile(knives and such are easy) and sells for only $60 with 
shipping.

Tim G

On Aug 5, 2008, at 8:33 AM, Paul T Williams wrote:


Hi List, 

I just found out about a great tool sharpening tool at 
www.worksharptools.com  Check it out!  It would save hours sharpening 
chisels, etc.  and not too spendy. 

Paul 


-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://www.moypiano.com/ptg/caut.php/attachments/20080805/a5eeb1bf/attachment.html