At 11:48 -0400 24/8/08, Greg Newell wrote: >...I have the task of thickness trimming on some prehung hammers >from S&S. The hammers came too thick for the vintage grand IÕm >working on as there is not sufficient clearance to allow reliable >individual hammer movement. >Ordinarily I would do this before hanging hammers but since these are >pre-hung É. well IÕm a bit stuck. You've bought the wrong hammers, which are most likely to be too heavy even if you find a way of planing them down to 10.5 or 11 mm wide. This would mean you'd end up with too heavy an action or too sluggish an action owing to the lead you add to compensate for the over-heavy hammers. Can't you send them back and get the proper lighter hammers for the early models? JD
This PTG archive page provided courtesy of Moy Piano Service, LLC