You're word is good enough for me. Thanks Ron. Jim -----Original Message----- From: caut-bounces at ptg.org [mailto:caut-bounces at ptg.org] On Behalf Of Ron Nossaman Sent: Thursday, November 06, 2008 2:37 PM To: caut at ptg.org Subject: Re: [CAUT] Drill bit for agraffes > With a stripped 7/32 agraffe can I drill and replace with ¼ agraffe? Yes, you can. > What size drill bit would I use if drilling a new hole for a ¼ inch > agraffe? Or, would I simply use the ¼ inch tap? You don't need to enlarge the hole, just run in the 1/4" tap with a drop of oil. Ron N
This PTG archive page provided courtesy of Moy Piano Service, LLC