Rolf, The current RX hammers which are available are not hard to work with. They are made somewhat similar to Renner hammers, and voice with similar techniques. They start hard and bright, and need plenty of low and upper shoulder needling. For universities we can special order the set of hammers pre-mounted from the factory, so if you contact Me at Kawai with the serial number I will order the set for you. A set takes a couple months to arrive from Japan, and it makes the hammer job much easier to complete quickly. Jim Busby installed a few of these sets earlier this year - hopefully he can comment on the voicing process and how they are sounding after some use. Don Mannino dmannino at kawaius.com -----Original Message----- From: caut-bounces at ptg.org [mailto:caut-bounces at ptg.org] On Behalf Of Rolf Von Walthausen Sent: Sunday, November 23, 2008 4:39 PM To: caut at ptg.org Subject: [CAUT] Kawai hammers Hello everyone: I have a piano faculty client with a KG-2A who needs a new set of hammers and would like me to use replacement Kawai hammers. I've never worked with these before and so would like to hear your experiences and any advice for getting these hammers to sound their best. Thanks for your help, and Eric good luck with all those Steinways at CCM. Rolf von Walthausen former CCM piano technician retired from institutional work & still kicking in the north woods...
This PTG archive page provided courtesy of Moy Piano Service, LLC