Hi Chris, What is "VSProfelt"? and where is it obtained? Thanks, Jim -----Original Message----- From: caut-bounces at ptg.org [mailto:caut-bounces at ptg.org] On Behalf Of Chris Solliday Sent: Friday, October 17, 2008 6:55 PM To: College and University Technicians Subject: Re: [CAUT] S&S Key Bushings I've been having good success with a variety of keybushings by using a drop of VSProfelt right on the pin marks and then cold brass cauls overnight. .003-.005 over for front rail and same size or .001 over for the balance. Chris Solliday ----- Original Message ----- From: "Jon Page" <jonpage at comcast.net> To: "caut list" <caut at ptg.org> Sent: Friday, October 17, 2008 9:08 AM Subject: [CAUT] S&S Key Bushings > Yesterday, I attempted to iron the key bushings on a 10 y/o L. > > The iron softened the glue more than it sized the opening. I > think the bushings actually swelled a bit because as I eased > the keys, I had to manually press the felt. > > There were two b/r felts which required reglueing. It reminded > me the pre-glued variety. > -- > > Regards, > > Jon Page
This PTG archive page provided courtesy of Moy Piano Service, LLC