[CAUT] Renner back action

[Jon Page]

>David made a good point about the dags. Lowering the tray necessitates
>cutting off the back top half of them at an angle. Starting about half way
>and cutting towards the rear lower corner.  A Japanese saw works 
>well for this.

But more so if you are locating the pivot forwards to the flange 
center line because
this will cause the rear of the tray to rotate downwards where it 
didn't before with
the pivot at the rear.
-- 

Regards,

Jon Page
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://www.moypiano.com/ptg/caut.php/attachments/20080904/3bbf079d/attachment.html