----- Original Message ----- From: "Ron Nossaman" <rnossaman at cox.net> > Even in this instance, there's plenty of gap from above, where the wire > diverges from the coil. > > And since someone is dead sure to ask again - no, you won't glue the coil > to the pin or plate. > Ron N I haven't tried it. Even on the pins I have tried it on that weren't driven deep, the CA just kind of pooled around the pin as if it weren't going down. So, I figured that's what would happen in this case as well. So, will it wick past tuning pin bushings to the block, too? Jeff
This PTG archive page provided courtesy of Moy Piano Service, LLC