Oh Yeah! I remember. I knew that name looked familiar. How's tricks? I still haven't made a damper guide rail yet. We have about 6 or 7 of the beasts, but hey, if they're not broke, don't fix it! I found all my notes though, thanks to you! :>) Now that I think about it, we replaced the dreaded double bushed guide rails. (Why they did this, I can't explain) However, since we replaced it with a standard bushing configuration on a blank rail, you should be good to go. Best, Paul From: Jeff Farris <Jfarris at mail.utexas.edu> To: <caut at ptg.org> Date: 06/23/2010 02:59 PM Subject: Re: [CAUT] Damper guide rail holes Hi Paul, Thanks. I was at Oberlin at the same time as you. I wasn’t in on the damper guide rail reproduction class, but I had it at Steinway with Kent Webb. I failed to write down the drill bit size. Thanks again, Jeff On 6/23/10 2:51 PM, "Paul T Williams" <pwilliams4 at unlnotes.unl.edu> wrote: Jeff, Ken Sloane at Oberlin at the Steinway seminar had us make a new guide rail from scratch two years ago. My project was also a B. We used a #15 drill bit for the main hole, then also put a counter sink hole on both sides for the felt to open up on both sides. We used no glue to install, just pull them through and trim up to look good. Then just used the pi-r-square to figure the radius for cutting the right felt width. I think 5/8" was about right. I think all the Steinway guides have the same damper wire widths. Hope this helps Paul From: Jeff Farris <Jfarris at mail.utexas.edu> To: "caut at ptg.org" <caut at ptg.org> Cc: tseay2 at austin.rr.com Date: 06/23/2010 02:32 PM Subject: [CAUT] Damper guide rail holes Hi List, Anyone know what size drill bit to use for drilling new damper wire guide rail holes for a Steinway B? Or where to find out? Thanks, Jeff Farris Jeff Farris Piano Technician School of Music UT Austin jfarris at mail.utexas.edu <jfarris at mail.utexas.edu> 512-471-0158 Jeff Farris Piano Technician School of Music UT Austin jfarris at mail.utexas.edu 512-471-0158 -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://ptg.org/pipermail/caut.php/attachments/20100623/2a566dc2/attachment.htm>
This PTG archive page provided courtesy of Moy Piano Service, LLC