[CAUT] S&S B desk glide parts

[tnrwim at aol.com]

If you're going to with the brass/nickel rail, you might need to remove the felt inside the rail groove. But that shouldn't be a problem since the brass rails are a  little thicker than the wood rails. You should also fill the groove where the wood rail came out of. The easiest way is to plane down the old rail.

Wim

Sent from my iPhone

On Jan 31, 2013, at 1:44 PM, Andrew Anderson <anrebe at gmail.com> wrote:

> I take care of an institutional B with those very thin glide rails.  Predictably they have broken again and again.  I ordered replacements from the mothership and they were concerned about matching citing a limited stock of older parts.  Turns out they were right.  What do you guys usually do with this situation as I doubt very much that those glides last very well anywhere else. ;-)
> 
> Andrew Anderson