<!doctype html public "-//W3C//DTD W3 HTML//EN"> <html><head><style type="text/css"></style><title>Re: Stanwood's method</title></head><body> <div>List,</div> <div><br></div> <div>OK, here we go. People always say the only stupid question is an</div> <div>unasked one, so here's my first not-stupid question. :-)</div> <div><br></div> <div>I think I understand how to do the individual key and shank/flange/</div> <div>hammer measuring but what do I need to do about the verdigris when</div> <div>doing down & upweight measurements? Wouldn't I need to try and</div> <div>clean and repin before I do those? </div> <div><br></div> <div>Or can I do just certain of the other measurements in order to</div> <div>determine which parts to order and then do the whole process?</div> <div><br></div> <div>Or should I just call Bob at Pianotek and ask him what to do in</div> <div>relation to ordering parts? Of course, then I might feel obligated</div> <div>to order there. :-)</div> <div><br></div> <div>It seems that I need to have the actual parts I'm going to use</div> <div>before<u> all</u> of this can be done. Am I correct?</div> <div><br></div> <div>This is my first part of not understanding. I'm not very</div> <div>mathematically inclined so I'm still at the point of my "eyes</div> <div>glazing over" when I'm trying to wade through this and understand</div> <div>it. :-)</div> <div><br></div> <div>Any advice appreciated.</div> <div><br></div> <div>Regards,</div> <div>Avery</div> </body> </html>