<html>
<body>
Wim,<br>
I'm guessing you mean the key slip, not the front rail which is part of
the key frame.<br>
If cosmetics is not an issue, and the pins that keep it in place
(attached to the bottom of the key slip and fitting in holes in the
keybed) are doing their job, a screw from the front of the key slip going
into the keyblock would work. I've never done it myself, but have seen
it. If you figure it correctly, you could use the screw holes that are
already there, the ones holding the screws that fit into the mortises
that are now too damaged to hold them. I would rather do it this way than
putting screws in from underneath the keybed. You'd need at least three
and then you'd have 5 screws between you and the action as opposed to
four by using the keyblocks. Of course best would be to repair the
mortises, but that may be more time than you have to spend on
it.<br><br>
Aaron <br><br>
At 11:38 AM 3/8/2006, you wrote:<br><br>
<blockquote type=cite class=cite cite="">A picture is worth a thousand
words...<br><br>
I'm not grasping exactly what you mean?&nbsp; Mortices in the
cheekblocks?&nbsp;&nbsp; <br><br>
David Ilvedson, RPT<br>
Pacifica, California<br><br>
<br><br>
<hr>
Original message<br>
From: Wimblees@aol.com<br>
To: caut@ptg.org<br>
Received: 3/8/2006 3:19:51 AM<br>
Subject: [CAUT] front rail delemna<br><br>
<font size=2>Both mortises that hold the front rail of a S&amp;S grand
have been damages, and the slot is now too big for the screw. What are
some ways to hold the rail on the piano? Two option I am considering is
drilling a hole through the front of the rail and attaching the rail to
the cheek block. The other option is to attach the rail with screws from
the bottom, like the way a lot of other grands have. The piano is in a
practice room, so cosmetics is not important. <br>
&nbsp;<br>
Wim <br>
</font>_______________________________________________<br>
caut list info:
<a href="https://www.moypiano.com/resources/#archives" eudora="autourl">
https://www.moypiano.com/resources/#archives</a></blockquote>
<x-sigsep><p></x-sigsep>
<br>
<font face="Eras Medium ITC">
------------------------------------------<br>
Aaron Bousel<br>
Registered Piano Technician, Piano Technicians Guild<br>
</font><font face="Eras Medium ITC" color="#0000FF">
abousel@comcast.net<br>
</font><font face="Eras Medium ITC">(413) 253-3846 (voice &amp;
fax)</font></body>
</html>