<html>
<body>
Wim, <br><br>
At 02:23 PM 3/8/2006, you wrote:<br>
<blockquote type=cite class=cite cite="">
<font face="Arial, Helvetica" size=2>In a message dated 3/8/2006 12:01:40
PM Central Standard Time, atodd@uh.edu writes:<br>
</font>
<dl>
<dd>I assume you're talking about the key slip? :-) If you are, something
I've seen done is to put (what I'd call) bullet shaped plugs pointing
down from inside the keyslip (glued in, of course) into corresponding
holes in the front of the keybed (where guide pins or screw would
normally be) to make a snug fit. Takes the cheek block completely out of
it. <br><br>
<dd>Hope I've explained well enough. I have 2 here that has been done to
and seems to work well. <br><br>
<dd>Avery <br>
<br>
</dl>Avery<br>
<br>
How are the bullet shaped plugs different from the pins that normally
hold the slip in place?<br>
<br>
Wim <br>
_______________________________________________</blockquote><br>
Just larger, thereby stronger without the extra help of the screws on the
cheeks, I guess. <br>
That's just the way this person does it. :-) <br><br>
Avery </body>
</html>