<br><font size=2 face="sans-serif">Yes, I have heard that too, but from
Steve Brady many years ago.</font>
<br>
<br><font size=2 face="sans-serif">Paul</font>
<br>
<br>
<br>
<table width=100%>
<tr valign=top>
<td width=40%><font size=1 face="sans-serif"><b>Jeff Tanner &lt;jtanner@mozart.sc.edu&gt;</b>
</font>
<br><font size=1 face="sans-serif">Sent by: caut-bounces@ptg.org</font>
<p><font size=1 face="sans-serif">10/20/2006 08:08 AM</font>
<table border>
<tr valign=top>
<td bgcolor=white>
<div align=center><font size=1 face="sans-serif">Please respond to<br>
College and University Technicians &lt;caut@ptg.org&gt;</font></div></table>
<br>
<td width=59%>
<table width=100%>
<tr valign=top>
<td>
<div align=right><font size=1 face="sans-serif">To</font></div>
<td><font size=1 face="sans-serif">College and University Technicians &lt;caut@ptg.org&gt;</font>
<tr valign=top>
<td>
<div align=right><font size=1 face="sans-serif">cc</font></div>
<td>
<tr valign=top>
<td>
<div align=right><font size=1 face="sans-serif">Subject</font></div>
<td><font size=1 face="sans-serif">Re: [CAUT] glue sizing bushings</font></table>
<br>
<table>
<tr valign=top>
<td>
<td></table>
<br></table>
<br>
<br>
<br>
<br><font size=3>On Oct 19, 2006, at 3:32 PM, Fred Sturm wrote:</font>
<br>
<br><font size=3>&nbsp; &nbsp; Yes, steam-sizing bushings is a standard
procedure for some of us. I</font>
<br><font size=3>wrote about it a few years back, and there was a bit of
discussion - check</font>
<br><font size=3>the archives.</font>
<p>
<br><font size=3>I believe that on more than one occasion I have also heard
Kent Webb describe soaking them with alcohol and water and inserting cauls.</font>
<br>
<br><font size=3>Jeff</font>
<br><font size=3><br>
</font>
<br><font size=1>Jeff Tanner, RPT</font>
<br><font size=1>University of South Carolina</font>
<br>
<br>
<br>
<br>