<div>Whether you raise or lower the bass or the treble depends on if there is any scrubing or not. If there is scrubing of the levers on the tray felt, you need to adjust the pin center like when you install a renner back action.
</div>
<div>Keith Roberts<br><br> </div>
<div><span class="gmail_quote">On 3/14/07, <b class="gmail_sendername"><a href="mailto:A440A@aol.com">A440A@aol.com</a></b> <<a href="mailto:A440A@aol.com">A440A@aol.com</a>> wrote:</span>
<blockquote class="gmail_quote" style="PADDING-LEFT: 1ex; MARGIN: 0px 0px 0px 0.8ex; BORDER-LEFT: #ccc 1px solid">Mark writes:<br><< >I've recently done some damper regulation on several Baldwins and noticed
<br>>the damper tray higher by a good 1/8th" in the Bass.<br><br>Tom replies,<br>What about plugging the hole on the treble block and re-drilling to<br>match the bass block? >><br><br> What about dropping the bass 1/16" and raising the treble by 1/16"?
<br>That should keep everything in the ball park inre action geometry while solving<br>the taper problem.<br>Regards,<br><br><br>Ed Foote RPT<br><a href="http://www.uk-piano.org/edfoote/index.html">http://www.uk-piano.org/edfoote/index.html
</a><br><a href="http://www.uk-piano.org/edfoote/well_tempered_piano.html">www.uk-piano.org/edfoote/well_tempered_piano.html</a><br><BR><BR><BR>**************************************<BR> AOL now offers free
<br>email to everyone. Find out more about what's free from AOL at<br><a href="http://www.aol.com">http://www.aol.com</a>.<br></blockquote></div><br>