Why was everything so oversized in those days for M and H.  Man, are they heavy!! Paul <table width=100%> <tr valign=top> <td width=40%>John Ross <jrpiano@win.eastlink.ca> Sent by: caut-bounces@ptg.org 10/30/2007 03:30 PM <table border> <tr valign=top> <td bgcolor=white> <div align=center>Please respond to College and University Technicians <caut@ptg.org></div></table> <td width=59%> <table width=100%> <tr valign=top> <td> <div align=right>To</div> <td>College and University Technicians <caut@ptg.org> <tr valign=top> <td> <div align=right>cc</div> <td> <tr valign=top> <td> <div align=right>Subject</div> <td>Re: [CAUT] new M & H plate screws?</table> <table> <tr valign=top> <td> <td></table> </table> Try John Schadler, 866 842-4266, of APSCO, he apparently kept the screw part, when he sold to Schaff. You might be wrong on the size 13, as I don't see it listed in the old APSCO catalogue John M. Ross Windsor, Nova Scotia, Canada <a href=mailto:jrpiano@win.eastlink.ca>jrpiano@win.eastlink.ca</a> ----- Original Message ----- From: <a href=mailto:cramer@brandonu.ca>Mark Cramer</a> To: <a href=mailto:caut@ptg.org>CAUT</a> Sent: Tuesday, October 30, 2007 3:28 PM Subject: [CAUT] new M & H plate screws? The plate screws on a 1926 M & H I’m reassembling are starting to get a little tired. The pin-block screws are #13’s and the rim screws are #16’s, neither of which seem to be available through Pianotek or Schaff.   Anyone have a lead on replacement screws of this size?   Meanwhile, I’ve left a message for Mark Burgett asking if they can supply these.   Thanks, Mark Cramer, Brandon University