<div>My mentor and his father had always thought that of the G2. He had one to restring recently and measured the board thickness and found it to be .425. or thicker. He took out his plane and shaved a few 100ths of an inch of the board. "What a difference." I didn't hear the piano but he said it sang. </div> <div> </div> <div>Not hard to do. Only takes a couple of hours with a good plane. He paid almost $300 for his plane........</div> <div> </div> <div>Keith Roberts<br><br></div> <div class="gmail_quote">On Dec 8, 2007 12:58 AM, Richard Brekne <<a href="mailto:ricb@pianostemmer.no">ricb@pianostemmer.no</a>> wrote:<br> <blockquote class="gmail_quote" style="PADDING-LEFT: 1ex; MARGIN: 0px 0px 0px 0.8ex; BORDER-LEFT: #ccc 1px solid">Yeah... sound along those lines.. thinish, too much midrange.... nasal<br>like.. The G2 kinda fits that.  Any other reasons why this occurs ?  How <br>does scaling tension fit in ? Panel stiffness... rib scale...<br>downbearing...  bridge dimensions etc.<br><br>I'm wondering what you can do short of major rebuilding work like<br>replacing a soundboard or the like to improve such instruments... <br><br>Cheers<br>RicB<br> <div class="Ih2E3d"><br><br>       Stingy in sound like the Yamaha G2? The board could be too thick.<br><br>       Keith Roberts<br><br><br><br></div> <div> <div></div> <div class="Wj3C7c">   On Dec 7, 2007 3:43 PM, Richard Brekne <ricb at <a href="http://pianostemmer.no/" target="_blank">pianostemmer.no</a>> wrote:<br><br>    > Hi folks.<br>    ><br>    > Just a general question I would like some thoughts on.  What are the <br>    > major reasons for a soundboard not having very good low frequency<br>    > response.  I've heard several makes from former eastern Europe...<br>    > Zimmerman comes to mind right away.... with a particular kind of <br>   nasal<br>    > sound to their instruments... and I've come to the conclusion<br>   that this<br>    > sound often corresponds to a panel with poor frequency response under<br>    > say... 300 hz.  Like turning down everything below 300 hz on a stereo <br>    > system... turning up the midrange... and leaving everything above<br>   2000<br>    > hz alone.<br>    ><br>    > I'd appreciate some thoughts on the matter.<br>    ><br>    > Cheers<br>    > RicB <br>    ><br><br></div></div></blockquote></div><br>