<!doctype html public "-//W3C//DTD W3 HTML//EN"> <html><head><style type="text/css"></style><title>[CAUT] Renner back action</title></head><body> <blockquote type="cite" cite><font face="Arial" color="#000000">All these things are good but if the pivot is too high why not just put on</font></blockquote> <blockquote type="cite" cite><font face="Arial" color="#000000">thicker key end felt?  Also, do you find that in moving the pivot pin</font></blockquote> <blockquote type="cite" cite><font face="Arial" color="#000000">forward to be on the same plane as the flange center that you often need to</font></blockquote> <blockquote type="cite" cite><font face="Arial" color="#000000">install a second tray spring?</font></blockquote> <div><br></div> <div>Each job needs to be assessed on its merits. If I'm replacing the damper felt</div> <div>or only installing assist springs (as with the last job), it's easier to move the pivot</div> <div>than to install new end felt. If the end felt is questionable and the dampers only</div> <div>need adjustment, then I would consider a thicker end felt.</div> <div><br></div> <div>Sometimes a second spring is needed for tray return after relocating the pivot inline.</div> <x-sigsep><pre>-- </pre></x-sigsep> <div><br> Regards,<br> <br> Jon Page</div> </body> </html>