<font size=2 face="sans-serif">If Ted says it's so, then it is!!</font>
<br>
<br><font size=2 face="sans-serif">Have your man re-measure, though, just
to make sure!</font>
<br>
<br><font size=2 face="sans-serif">Best to you, Ted,</font>
<br>
<br><font size=2 face="sans-serif">Paul</font>
<br>
<br>
<br>
<br>
<br>
<br>
<table width=100%>
<tr valign=top>
<td><font size=1 color=#5f5f5f face="sans-serif">From:</font>
<td><font size=1 face="sans-serif">Edward Sambell &lt;esambell@yahoo.com&gt;</font>
<tr valign=top>
<td><font size=1 color=#5f5f5f face="sans-serif">To:</font>
<td><font size=1 face="sans-serif">&quot;caut@ptg.org&quot; &lt;caut@ptg.org&gt;</font>
<tr valign=top>
<td><font size=1 color=#5f5f5f face="sans-serif">Date:</font>
<td><font size=1 face="sans-serif">08/27/2011 03:42 PM</font>
<tr valign=top>
<td><font size=1 color=#5f5f5f face="sans-serif">Subject:</font>
<td><font size=1 face="sans-serif">Re: [CAUT] Bösendorfer question</font></table>
<br>
<hr noshade>
<br>
<br>
<br><font size=3 face="Times">Stan,</font>
<br>
<br><font size=3 face="Times">I have worked on many Bosendorfers and the
keypin diameters were .135&quot;. In fact I am doing one now, and it too
has .135&quot; on both rails. I will be rebushing with leather. The keys
are made by Herrberger Brooks (UK) but this size seems to be common with
European pianos.</font>
<br>
<br><font size=3 face="Times">Regards, Ted Sambell</font>
<br>
<br>
<hr><font size=2 face="Arial"><b>From:</b> Stan Kroeker &lt;smkroeker@shaw.ca&gt;<b><br>
To:</b> caut@ptg.org<b><br>
Sent:</b> Saturday, August 27, 2011 1:26:03 PM<b><br>
Subject:</b> [CAUT] Bösendorfer question</font><font size=3 face="Times"><br>
<br>
Hello all,<br>
<br>
Have just received a set of Bösendorfer keys from a colleague for rebushing
and am worried that the keypin diameters may not have been measured accurately.
&nbsp;Is anyone able to share these specs?<br>
<br>
Best regards from the sun-baked Canadian prairie!<br>
<br>
Stan Kroeker, RPT<br>
</font>
<br>
<br>