<font size=2 face="sans-serif">Hi Wim!</font>
<br>
<br><font size=2 face="sans-serif">I've never had anything too loose with
new parts. More often, too tight where I nearly strip the screw slot!
That sounds unusual...</font>
<br>
<br><font size=2 face="sans-serif">It can't hurt to try the superglue thing....it
works on tuning pins, so why not? It would be a shame to have to
remove the new hammer and start over, but, it might need to happen. Have
you asked Kent Webb? Worth him knowing for QA in the factory...</font>
<br>
<br><font size=2 face="sans-serif">Good luck,</font>
<br><font size=2 face="sans-serif">Paul</font>
<br>
<br>
<br>
<br>
<table width=100%>
<tr valign=top>
<td><font size=1 color=#5f5f5f face="sans-serif">From:</font>
<td><font size=1 face="sans-serif">tnrwim@aol.com</font>
<tr valign=top>
<td><font size=1 color=#5f5f5f face="sans-serif">To:</font>
<td><font size=1 face="sans-serif">caut@ptg.org</font>
<tr valign=top>
<td><font size=1 color=#5f5f5f face="sans-serif">Date:</font>
<td><font size=1 face="sans-serif">11/09/2011 02:42 PM</font>
<tr valign=top>
<td><font size=1 color=#5f5f5f face="sans-serif">Subject:</font>
<td><font size=1 face="sans-serif">[CAUT] loose drops</font></table>
<br>
<hr noshade>
<br>
<br>
<br><font size=2 face="Arial">I just put on a new set of S&S h/s/f.
About 6 drop screws are so loose that when I try to screw them in, they
push all the way through the flange</font>
<br><font size=2 face="Arial"> </font>
<br><font size=2 face="Arial">1. Has anyone else have had this problem?</font>
<br><font size=2 face="Arial">2. Should I replace the flange, or can I
put a drop of super glue on them?</font>
<br><font size=2 face="Arial"> </font>
<br><font size=2 face="Arial">Wim Blees, RPT</font>
<br><font size=2 face="Arial">Hawaii<br>
</font>
<br><font size=2 face="Arial"> </font>
<br>
<br>