<HTML> <HEAD> <TITLE>Re: [CAUT] loose drops</TITLE> </HEAD> <BODY> If it is within warranty, call them for replacements. But in the meantime you can successfully size the hole with CA glue. I would take the screws out, spray them with mold release, apply CA glue to the hole screw in the screws, and spray with accelerator (I like the aerosol kind). You may need to repeat given that they are as loose as you describe. Alan McCoy <HR ALIGN=CENTER SIZE="3" WIDTH="95%">From: <<a href="tnrwim@aol.com">tnrwim@aol.com</a>> Reply-To: CAUTlist <<a href="caut@ptg.org">caut@ptg.org</a>> Date: Wed, 9 Nov 2011 12:35:18 -0800 To: CAUTlist <<a href="caut@ptg.org">caut@ptg.org</a>> Subject: [CAUT] loose drops I just put on a new set of S&S h/s/f. About 6 drop screws are so loose that when I try to screw them in, they push all the way through the flange   1. Has anyone else have had this problem? 2. Should I replace the flange, or can I put a drop of super glue on them?   Wim Blees, RPT Hawaii   </BODY> </HTML>