<html> <body> Wim, At 02:42 PM 1/14/2005, you wrote: <blockquote type=cite class=cite cite="">In a message dated 1/14/05 2:13:40 P.M. Central Standard Time, atodd@uh.edu writes: <dl> <dd>This is a question I should know the answer to but I don't. :-( Is there a way to tilt the wippen so it will sit correctly on the capstan without disturbing the jack tender/let-off button alignment? Considering the shape of the Steinway flange. </dl>Avery   You need to visualize which way you want the wippen to tilt. There are three ways to move the wippen. The first is moving the whole wippen from left to right, by repositioning the flange in the screw hole. Then you can angle the front of the wippen to the right or left by adding traveling paper to the whole length of the flange. </blockquote> I know and have done both of those. <blockquote type=cite class=cite cite="">Then you can tilt the top of the wippen from left to right by adding traveling paper to only the bottom of the flange. </blockquote> This is what I was missing. Thanks. <blockquote type=cite class=cite cite="">To get the wippen positioned correctly on the cushion and the jack tender, you need to do a little of all three.   Good luck   Wim </blockquote> Avery </body> </html>